Ver Feed RSS

Geeek

Mikrotik Versão 5!

Avaliação: 2 votos, 4,50 média.
Foi lançada a versão estável do routerOS Mikrotik 5.0, 5.1, 5.2, 5.3, 5.4, 5.5 ... 5.6 ... 5.19

Nome:      made_mfm.png
Visitas:     12106
Tamanho:  13,3 KB


O que há de novo na versão 5.6 (2011-Aug-02 14:45):

*) fixed ssh server crashing when sessions were interrupted
*) ipsec - fix a problem which could silently remove a manual policy from the kernel if the peer configuration has 'generate-policy' set to 'yes' and if the policy matches with the traffic selector of a SA being removed on the responder side, also fix a problem that some generated policies may stay in kernel after relevant SA was removed;
*) profiler - correctly show idle task on RB1200;
*) webfig - fix dual nstreme interface setting lists;
*) webfig - fix Wireless Access/Connect List editing;
*) webfig - fix bitrate presentation in simple queues (show 1.5M as 1500k);
*) fixed micro-sd access on RB400 not to stop everything else;
*) sstp - when server certificate verification is enabled for sstp client, it will additionally compare IP addresses found in certificate's subjectAltName and subject CN to the real address, DNS names are ignored;
*) tftp - optional block counter roll-over support;
*) hotspot - fixed possible crash in case of multiple Radius CoA requests;
*) userman - speedup user deletion with big log size, note that first userman startup after this update may take few minutes if the log size is in hundreds of MB;
*) mpls - added support for enabling/disabling control word usage for BGP based VPLS tunnels (both - Cisco and RFC 4761 based);
*) mpls - added support for auto-discovery of VPLS NLRI encoding method for Cisco BGP based VPLS tunnels;
*) winbox - sometimes after disconnecting, winbox could not connect back;
*) bgp - allow parallel operation of RFC4761 "l2vpn" and draft-ietf-l2vpn-signaling "l2vpn-cisco" BGP VPLS variants inside single peering session.
*) console - ":resolve" command now returns IPv6 address for domain names that have only IPv6 address records;
*) snmp - provide ups alarms for bad or low battery or for ups overload;
*) route - fixed SNMP getnext queries, were failing to find next prefix in the OID order;

O que há de novo na versão 5.5 (2011-Jun-20 14:43): *)

*)console - resolved problem that appeared in version 5.4. it caused 'sup-output' command to crash console on systems with many ethernet interfaces or very long interface names.
*)serial console - do not automatically send login prompt to attached usb modem if no other serial port exists;
*)winbox - fixed scrolling in terminal window;
*)webfig - encrypt whole session even in non https mode;
*)do not show contents of skin files to users without 'sensitive' permission;

O que há de novo na versão 5.4 (2011-May-27 13:18):

*) webfig - do not try to open many windows if first open was blocked by browser;
*) RB4xx ether1 port flapping fixed;

O que há de novo na versão 5.3 (2011-May-25 15:19):

*) snmp - fix table get next with partial row keys;
*) snmp - respond from correct source address when multiple exist;
*) snmp - fix possible interface disappearing when walking ipNetToMediaTable;
*) snmp - fix possible memory leak;
*) ipsec - flush SAs and inform peer when rebooting or shutting down; *) openvpn - fixed crash;
*) implemented terminal in WebFig;
*) implemented Skin mode in WebFig;
*) added support for more Broadcom Tigon3 based ethernet cards;
*) winbox - fixed byte to KiB, MiB and GiB conversion (digit after decimal point could be a bit off);
*) console - align numbers right in tabular print output;
*) fixed RB450G, RB750G switch chip slow ethernet problem;
*) fix vlan disable not taking effect;
*) userman - fix Authorize.Net payment bypass;
*) userman - added profile option to overwrite shared users option in user settings when profile is activated;
*) userman - fix db backup if it's size exceeds 2G;
*) wireless - merged ht-extension-channels in to channel-width;

O que há de novo na versão 5.2 (2011-abr-26 16:09):

*) Webfig fixo;
*) Console - Corrigido problema com a geração supout e exportação de ficheiros que apareceu na versão 5.1, que estava causando console para entrar loop ocupado em algumas placas;
*) Ssh cliente - endereço de origem adicionados e as opções de comando remoto;
User Manager *) - adicionado / profile UserManager ferramenta;
*) De rotas - Corrigido o problema com a falta de linhas conectadas;

O que há de novo no 5.1 (2011-abr-08 00:55):

*) ipsec - fix SA lifetime display when timezone offset does not equal 0;
*) ipsec - now default DPD interval is 2 min for new configurations;
*) webfig - make bandwidth-test work;
*) fixed problem - wireless package got disabled after upgrading from v4;
*) sstp - fix problems on multicore systems;

O que há de novo na versão 5.0 (2011-Mar-31 11:33)

*) route - fixed cause of crashes when handling multipath routes;
*) route - fixed limit on maximum active IPv6 route count,
was causing issues with more than 2000 active routes;
*) ipsec - added command kill-connections under remote-peers;
*) ipsec - fix responder side phase2 negotiation problem
which prevented more than one Windows7 host to initiate SA;
*) fixed vrrp - interface was invalid after undoing remove;
*) winbox - added more detailed /interface ethernet stats;
*) winbox - added ability to send e-mail;
*) winbox - added missing 'set-metric' parameter
in 'Routing/Prefix List';
*) wireless - 802.11 dynamic distance fix;
*) fixed problem - packages could not be uninstalled if disk was full;
*) fixed problem - some of the RouterBOARDS did not reboot properly sometimes;
*) fixed problem - VLANs on bridge interface did not work;
*) ssh - client supports public key authentication;

Eu ja estava usando a versão 5.0 rc11 a tempos e ja estava muito madura, agora com essas correções creio que, esteja bem melhor.
O pessoal que ja usava também deva ter percebido o bug de vlans sobre bridge que foi corrigido.
Para quem faz acesso ssh com chave pública tbm deva ter notado alguns bus que foram corrigido nesta versão.

Link para download aqui:
MikroTik Routers and Wireless

Todos as versões de Mikrotik aqui:

http://mikrotik-software.de/downloads/

Atualizado 09-08-2012 em 17:04 por Geeek (update!)

Categorias
Artigos , Noticias , Dicas , Reviews , Negócios , Tutoriais

Comentários

Página 3 de 3 PrimeiroPrimeiro 123
  1. Avatar de araxa
    Bom dia Geek:
    me tire uma duvida eu tenho uma RB 1200 fiz atualização 6.01 Beta nela e começou uns
    erros estranho de DNS e eu não concegui fazer Downgrade de forma alguma voce como
    perito em Microtick nao alguma dica para mim:

    Grato Marcio Araxá MG
  2. Avatar de Geeek
    Citação Postado originalmente por araxa
    Bom dia Geek:
    me tire uma duvida eu tenho uma RB 1200 fiz atualização 6.01 Beta nela e começou uns
    erros estranho de DNS e eu não concegui fazer Downgrade de forma alguma voce como
    perito em Microtick nao alguma dica para mim:

    Grato Marcio Araxá MG
    Jogue os pacotes da versao anterios e va em /system package downgrade
    dai ela vai pedir pra rebootar entao é so dar ok
Página 3 de 3 PrimeiroPrimeiro 123

+ Enviar Comentário