Re: Cyclades PR1000IP X BLF Embratel
FIZ A CONFIGURACAO MAS NAO DEU CERTO MEU FIREWALL NAO SOBE PLACA DE REDE CONECTADA NO ROUTER, NO PRINT DO ROUTER MINHA CONF ESTA ASSIM:
1. Fast Ethernet 2. Slot 1 (SWAN)
Select option ==> 2
Channel 1
Encapsulation Frame Relay
IP protocol active
Interface Numbered
Primary IP address 192.168.162.1
Subnet mask 255.255.255.0
IP MTU 1500
IP Fragmentation bit DF - accept
NAT - Address Scope Global
ICMP Port inactive
Incoming Filter List None
Detailed Incoming IP Accounting Process inactive
Outgoing Filter List None
Detailed Outgoing IP Accounting Process inactive
Routing of Broadcast Messages inactive
Interface Transparent Bridge Inactive
Sync mode
External Clock Source
Don't invert clock phase for transmission
Interface V.35
Bandwidth 0
IP Traffic Control List None
Encapsulation Type RFC1490 - IETF
SNAP IP inactive
LMI type Group of 4
Alternative DLCI routing disabled for this link
T391 in seconds 10
N391 6
N392 3
N393 4
FRF-12 - without fragmentation
Number of DLCI's 1
Frame Relay MAP
-----------------------------------------------------
# DLCI Remote IP addr Local IP addr CIR Pred Ctrl
-----------------------------------------------------
01 100 200.250.159.113 100 Dis None
-----------------------------------------------------
DLCI Traffic Control inactive
SNMP interface :
Interface UP/Down TRAP Disable
IP Static Routes
Destination Subnet Mask Gateway/Interf Metric/Bkp/RIP OSPF/ExType
Default Gateway 200.250.159.113 1 no no no