+ Responder ao Tópico



  1. #1
    Diogenes
    Visitante

    Padrão Configuração Roteador Cisco 2600

    Como faço para configurar um CISCO 2600 com 4(quatro) portas seriais, a configuração que fiz o provedor só consegue exergar uma das portas.
    grt

  2. #2
    Vascon
    Visitante

    Padrão Configuração Roteador Cisco 2600 - Atual

    Olá pessoal
    Para facilitar a minha configuração atual é a seguinte, na verdade só umas das portas conseguir acessar, alguém poderia fazer uma analise ver se tem algum erro: São 4 portas seriais e 2 ethernet

    router#sh int f0/0

    FastEthernet0/0 is up, line protocol is up

    Hardware is AmdFE, address is 0012.80e5.45e0 (bia 0012.80e5.45e0)

    Description: *** LIGADA A PORTA X DO SWITCH Y ***

    Internet address is 10.63.0.126/25

    MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation ARPA, loopback not set

    Keepalive not set

    Auto-duplex, Auto Speed, 100BaseTX/FX

    ARP type: ARPA, ARP Timeout 04:00:00

    Last input never, output 00:33:47, output hang never

    Last clearing of "show interface" counters never

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

    0 watchdog

    0 input packets with dribble condition detected

    2 packets output, 120 bytes, 0 underruns

    0 output errors, 0 collisions, 0 interface resets

    0 babbles, 0 late collision, 0 deferred

    2 lost carrier, 0 no carrier

    0 output buffer failures, 0 output buffers swapped out


    FastEthernet0/1 is up, line protocol is up

    Hardware is AmdFE, address is 0012.80e5.45e1 (bia 0012.80e5.45e1)

    Description: *** LIGADA A PORTA X DO SWITCH Y ***

    Internet address is 10.63.0.254/25

    MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation ARPA, loopback not set

    Keepalive not set

    Auto-duplex, Auto Speed, 100BaseTX/FX

    ARP type: ARPA, ARP Timeout 04:00:00

    Last input never, output 00:35:39, output hang never

    Last clearing of "show interface" counters never

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

    0 watchdog

    0 input packets with dribble condition detected

    2 packets output, 120 bytes, 0 underruns

    0 output errors, 0 collisions, 0 interface resets

    0 babbles, 0 late collision, 0 deferred
    2 lost carrier, 0 no carrier

    0 output buffer failures, 0 output buffers swapped out


    Serial0/0 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CIRCUITO SDR5055705 ***

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF, loopback not set

    Keepalive set (10 sec)

    LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down

    LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0

    LMI DLCI 0 LMI type is CCITT frame relay DTE

    Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0

    Last input never, output never, output hang never

    Last clearing of "show interface" counters 00:36:57

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes, 0 no buffer

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

    0 packets output, 0 bytes, 0 underruns

    0 output errors, 0 collisions, 1 interface resets

    0 output buffer failures, 0 output buffers swapped out

    0 carrier transitions

    DCD=up DSR=up DTR=down RTS=down CTS=up



    Serial0/1 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CIRCUITO AAA1234567 ***

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF, loopback not set

    Keepalive set (10 sec)

    LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down

    LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0

    LMI DLCI 0 LMI type is CCITT frame relay DTE

    Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0

    Last input never, output never, output hang never

    Last clearing of "show interface" counters 00:37:39

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes, 0 no buffer

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

    0 packets output, 0 bytes, 0 underruns

    0 output errors, 0 collisions, 1 interface resets

    0 output buffer failures, 0 output buffers swapped out

    0 carrier transitions

    DCD=up DSR=up DTR=down RTS=down CTS=up





    Serial0/2 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CIRCUITO AAA1234568 ***

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF, loopback not set

    Keepalive set (10 sec)

    LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down

    LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0

    LMI DLCI 0 LMI type is CCITT frame relay DTE

    Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0

    Last input never, output never, output hang never

    Last clearing of "show interface" counters 00:38:04

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes, 0 no buffer

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

    0 packets output, 0 bytes, 0 underruns

    0 output errors, 0 collisions, 1 interface resets

    0 output buffer failures, 0 output buffers swapped out

    0 carrier transitions

    DCD=up DSR=up DTR=down RTS=down CTS=up



    Serial0/3 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CIRCUITO AAA1234569 ***

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF, loopback not set

    Keepalive set (10 sec)

    LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down

    LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0

    LMI DLCI 0 LMI type is CCITT frame relay DTE

    Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0

    Last input never, output never, output hang never

    Last clearing of "show interface" counters 00:39:08

    Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

    Queueing strategy: fifo

    Output queue: 0/40 (size/max)

    5 minute input rate 0 bits/sec, 0 packets/sec

    5 minute output rate 0 bits/sec, 0 packets/sec

    0 packets input, 0 bytes, 0 no buffer

    Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

    0 packets output, 0 bytes, 0 underruns

    0 output errors, 0 collisions, 1 interface resets

    0 output buffer failures, 0 output buffers swapped out

    0 carrier transitions

    DCD=up DSR=up DTR=down RTS=down CTS=up





    Serial0/0.2 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CONECTADA AO SITE CENTRAL ***

    Internet address is 10.63.240.2/30

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF

    Last clearing of "show interface" counters never




    Serial0/1.2 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CONECTADA AO SITE CENTRAL ***

    Internet address is 10.63.240.6/30

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF

    Last clearing of "show interface" counters never


    Serial0/2.2 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CONECTADA AO SITE CENTRAL ***

    Internet address is 10.63.240.10/30

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF

    Last clearing of "show interface" counters never

    Serial0/3.2 is down, line protocol is down

    Hardware is PowerQUICC Serial

    Description: *** CONECTADA AO SITE CENTRAL ***

    Internet address is 10.63.240.14/30

    MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

    reliability 255/255, txload 1/255, rxload 1/255

    Encapsulation FRAME-RELAY IETF

    Last clearing of "show interface" counters never


    router#sh flash

    System flash directory:

    File Length Name/status

    1 17725320 c2600-is-mz.123-13.bin

    [17725384 bytes used, 15829044 available, 33554428 total]

    32768K bytes of processor board System flash (Read/Write)