Olá pessoal
Estou precisando de uma ajuda, estou tentando instalar o dispositivo VT6105 Ethernet, ja instalei o modulo forcedeth.c , porem quando tento habilitar o dispositivo da erro, o Linux nao acha o dispositivo, o modulo está instalado,
Detalhes do dispositivo
00:0f.0 Ethernet controller: nVidia Corporation MCP73 Ethernet (rev a2)
Subsystem: Giga-byte Technology Unknown device e000
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 (250ns min, 5000ns max)
Interrupt: pin A routed to IRQ 15
Region 0: Memory at e5109000 (32-bit, non-prefetchable) [size=4K]
Region 1: I/O ports at e000 [size=8]
Region 2: Memory at e510a000 (32-bit, non-prefetchable) [size=256]
Region 3: Memory at e5106000 (32-bit, non-prefetchable) [size=16]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [50] Message Signalled Interrupts: 64bit+ Queue=0/3 Enable-
Address: 0000000000000000 Data: 0000
Alguem pode me ajudar ?