Cbq não funciona,...instalei o iproute2 eo shapercfg configurei o cbq, as regras, tudo direitinho (eu acho) mas não funciona...????
Qual é a saida eth1 ou eth0???? ops:
ETH1-internet
ETH0-rede interna
Grato a atenção...
Cbq não funciona,...instalei o iproute2 eo shapercfg configurei o cbq, as regras, tudo direitinho (eu acho) mas não funciona...????
Qual é a saida eth1 ou eth0???? ops:
ETH1-internet
ETH0-rede interna
Grato a atenção...
Li muito bom o artigo mas como faço isso aqui abaixo????Postado originalmente por bauer
OBS: uso RH9
Opções do Kernel para o CBQ Funcionar
Code Matury Level Options --->[*] Prompt for development and/or incomplete code/drivers
Networking Options --->
<*> Packet socket[*] Routing Messages
<*> Unix domain sockets[*] TCP/IP networking[*] IP advanced router[*] IP Policy routing[*] IP equal cost multipath[*] IP use TOS value as route key[*] IP verbose route monitoring[*] IP large routing tables[*] IP fast network address translation[*] optimize as houte not host
QoS and/or fair queueing --->[*] QoS and/or fair queueing
< M > CBQ packet sheduler
< M > CSZ packet sheduler
< M > The simplest PRIO pseudosheduler
< M > RED queue
< M > SFQ queue
< M > TEQL queue
< M > TBF queue[*] QoS support[*] Rate estimator[*] Packet classifier API
< M > Routing table based classifier
< M > Firewall based classifier
< M > U32 classifier
< M > Special RSVP classifier
< M > Special RSVP classifier for IPv6[*] Ingress traffic policing
Que comando eu dou para fazr isso...eu uso RH9.
Grato